GE/Jasco ZW4201 Used Product Addition Difficulties - Devices & Integrations - SmartThings Community

June 01,2024

I bought a couple of these from an estate sale and found very little comprehensive information on how to get them included at my house. I tried several methods of setup including the factory reset (hold the button for 3 sec while plugging it in) with no avail. It was getting very frustrating. Finally I was able to piece together things from 2 posts to get them to work. Here is what worked for me: From the home page in the ST app, select the three lines in the upper left corner This slides

Ezlo Platform Z-Wave supported Command Classes & Devices - Official Announcements - Ezlo Community

Matter - smart home connectivity standard (formerly Project CHIP) - #542 by all4dom - Devices & Integrations - SmartThings Community

Child Device Status Updates After ZWave Direct Association - Devices & Integrations - SmartThings Community

PDF) ZMAD: Lightweight Model-Based Anomaly Detection for the Structured Z-Wave Protocol

Z-Wave Device issue in the past few weeks (Since mass device delete) - Devices & Integrations - SmartThings Community

Edge Drivers for old zwave devices? - Devices & Integrations - SmartThings Community

Groovy deprecation on ST plaform - October 15, 2022 - 💬 Lounge - Hubitat

Smartthings Hardware being licensed to Aeotec? - Devices & Integrations - SmartThings Community

Integrate z wave with home assistant

Non-Jasco add-on switch? - Devices & Integrations - SmartThings Community

Problems resetting SmartThings motion and openclose sensors - Connected Things - SmartThings Community

Teardown: Ruggedized smart switch - EDN

GE switches stopped working (April 2023) - General Discussion - SmartThings Community

How To Exclude A GE Z-Wave Outlet From Your Home Automation System